Angle Gauge Sets for Bitzenburger Fletching Jig

Description

Angle Gauge Set for Bitzenburger Fletching Jig
I love my Bitzenburger jig, but could never get it in the same position twice.
These gauges let you to consistently set your fixture at 0, 1, 2, and 3 degrees. No more guessing at pencil marks.
Included in the
full kit
:
-For Right Helical Clamp - 1, 2, and 3 degree
-For Straight Clamp - 1 Right, 2 Right, 0 Straight, 1 Left, and 2 Left degree
-For Left Helical Clamp - 1, and 2 degree
-Vinyl Covered Steel Stock
-Gauge Holder
-9/32 Allen Wrench
-Rubber band
-Paper Gauge
-Instructions
Instructions:
1. Loosen the set screws on the fixture.
2. Use the supplied clamp to hold the gauge to the arrow in the fixture.
3. Place supplied metal stock on top of gauge against magnets.
3. Apply slight pressure between the gauge and the fixture allowing it to sit flat against the magnets.
4. Retighten your set screws.
5. Open your beer.
6. Start fletching.
Step 5 can be moved before any step in the process.
The included paper gauge can be taped to an arrow to verify angles.
Let me know if you have ideas for design changes, new products, or colors for future items.
Gauges are 3D printed PLA plastic, colors may vary slightly.
Jig and clamps are not included.
Note: In some cases the Bitzenburger jig may have to be slightly filed, pictured above, in order to give clearance
for the 3 degree right clamp if you run your fletching forward far enough.
Shipped with USPS First Class. Continental 48 only.